Been meaning to make some carving tools for a while so here we are....Made using a O-1 tool steel,brass tubing ferrules & various woods.Top row,Maple,Mahogany,Beech & Yew.Bottom row,Sapele,African Blackwood,Boxwood,Walnut & Piquia Amarello.The gouges were made on the lathe by drilling a hole the appropriate width for the chosen sweep down the center then half the material was ground away to leave a U shaped cross section that is easilly sharpened into a gouge.The largest gouge is also forged a little to open the sweep so that an 8mm diameter drill rod yeilds a gouge with a 9mm sweep(I'm not that enamoured with this tool,I'll be making another 9mm sweep gouge when the 13mm drill rod arrives.)The straight chisels were 5mm drill rod that I heated in a propane/butane torch until red hot then hammer forged to rough shape then ground to final dimension on the lap grinder.The skew & fingernail chisels were simply ground.All have been successfully heat treated & take & hold an edge that is "shaving sharp".I thoroughly enjoy making these wee tools & imagine I'll have a lot more before very long!
